[Metalab] 3D-Druck

[Thomas Mieling]

Heating and regulation of the fan both work.

Thomas
Am 09.09.2013 um 20:58 schrieb Marius Kintel <marius at kintel.net>:

> On 2013-09-09, at 2:53 PM, Thomas Mieling <thomas at mieling.at> wrote:
> 
>> I attached the signal-wires of the y-axis to the driver-board of the extruder.
> 
> Perfect.
> Did you manage to test any of the extruder controller functions (like heating), to further debug the issue, or does it appear as if the extruder controller simply doesn't communicate with the motherboard.
> I think that the motherboard will report the extruder controller version on startup on the serial port.
> Unfortunately, the protocol is binary so it's a bit tricky to debug without using RepG or MakerWare..
> 
> -Marius
> 
> 
> _______________________________________________
> Metalab mailing list
> Metalab at lists.metalab.at
> https://lists.metalab.at/mailman/listinfo/metalab

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 495 bytes
Desc: Message signed with OpenPGP using GPGMail
URL: <http://lists.metalab.at/pipermail/metalab/attachments/20130909/417c1e18/attachment.sig>