[Metalab] 3D-Druck

[Thomas Mieling]

I attached the signal-wires of the y-axis to the driver-board of the extruder.
Using the replicatorG-control panel, I sent commands to move the y-axis, which - in reality - moved the stepper motor of the extruder. Therefore i know that both the stepper motor and the driver-board work.
I hope this is understandable…

Thomas
Am 09.09.2013 um 20:44 schrieb Marius Kintel <marius at kintel.net>:

> On 2013-09-09, at 2:41 PM, Thomas Mieling <thomas at mieling.at> wrote:
> 
>> I tried this today as well, but no success…
>> Firmware version 3.1 (the latest) did not solve the problem,
>> the i flashed an older version (before a change in the toolhead-protocol), but this did not change anything either.
>> 
> 
> Hm, I'm confused: You wrote that the stepper motors and stepper drivers are OK - how did you test that if the extruder stepper doesn't move?
> 
> -Marius
> 
> 
> _______________________________________________
> Metalab mailing list
> Metalab at lists.metalab.at
> https://lists.metalab.at/mailman/listinfo/metalab

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 495 bytes
Desc: Message signed with OpenPGP using GPGMail
URL: <http://lists.metalab.at/pipermail/metalab/attachments/20130909/0915968c/attachment.sig>