[Metalab] 3D-Druck

[Marius Kintel]

On 2013-09-09, at 2:41 PM, Thomas Mieling <thomas at mieling.at> wrote:

> I tried this today as well, but no success…
> Firmware version 3.1 (the latest) did not solve the problem,
> the i flashed an older version (before a change in the toolhead-protocol), but this did not change anything either.
> 

Hm, I'm confused: You wrote that the stepper motors and stepper drivers are OK - how did you test that if the extruder stepper doesn't move?

 -Marius