[Metalab] 3D-Druck

[Thomas Mieling]

I tried this today as well, but no success…
Firmware version 3.1 (the latest) did not solve the problem,
the i flashed an older version (before a change in the toolhead-protocol), but this did not change anything either.

Thomas
Am 09.09.2013 um 20:26 schrieb Marius Kintel <marius at kintel.net>:

> On 2013-09-09, at 2:19 PM, Thomas Mieling <thomas at mieling.at> wrote:
>> 
>> Das Problem scheint eher die Firmware (oder ReplicatorG) zu sein.
>> 
> I would try upgrading the firmware.
> Note that there are two firmwares: One for the motherboard and one for the extruder controller. There should be a separate USB cable attached for firmware upgrade of the extruder controller (and marked as such).
> 
> Makerbot actually supports Thing-o-matics in their new MakerWare software. I would recommend giving that a try:
> http://www.makerbot.com/support/thingomatic/documentation/makerware/
> 
> -Marius
> 
> 
> _______________________________________________
> Metalab mailing list
> Metalab at lists.metalab.at
> https://lists.metalab.at/mailman/listinfo/metalab

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 495 bytes
Desc: Message signed with OpenPGP using GPGMail
URL: <http://lists.metalab.at/pipermail/metalab/attachments/20130909/bbc75043/attachment.sig>